Picotest EMI Bundle J2180A Preamp & EMI Probes
What's included:
Hand Held EMI Probe Set (EM-6992)
- 6 cm Loop (EM-6993)
- 3 cm Loop (EM-6994)
- 1 cm Loop (EM-6995)
- 3.6 cm Ball (EM-6996)
- Stub (EM-6997)
All probes supplied with BNC connector and custom carrying case.
- J2180A 0.1Hz-100MHz Ultra Low Noise Preamp (J2180A)
- J2170B High PSRR Power Adapter
- User manual
- 1 Year Warranty
Picotest J2180A Ultra Low Noise Preamps
KEY FEATURES:
- Works with all oscilloscopes, spectrum analyzers and network analyzers
- Active DC bias loop maintains low DC output voltage
- High input impedance compatible with typical probes minimizes circuit loading
- Low noise
- Works with near field probes for EMI troubleshooting
- Improves effective noise floor and spurious response
- Very wide bandwidth
- Compatible with J2170B power supply
What's included:
- J2180A 0.1Hz-100MHz Ultra Low Noise Preamp
- J2170B High PSRR Power Adapter
- User manual
- 1 Year Warranty
Models:
- J2180A - J2180A 0.1Hz-100MHz Ultra Low Noise Preamp
- J2180A-20 - J2180A-20 20Hz-100MHz Ultra Low Noise Preamp
The J2180A low noise preamplifier provides a fixed, AC coupled 20dB gain while converting a 1 MOhm input impedance to a 50 Ohm output impedance. With a 3dB bandwidth of 0.1Hz to 100MHz, the preamplifier improves the sensitivity of oscilloscopes, network analyzers and spectrum analyzers while reducing the effective noise floor and spurious response. The preamplifier can also serve as a low frequency DC blocker for a spectrum analyzer or you can use it to connect a high input impedance oscilloscope probe to 50 Ohm equipment.
The J2180A preamplifier offers very low noise, fast 100V/uS slew rate for pulse applications and very low distortion for audio applications. A typical noise plot shows the noise is 2.4nV/rt_Hz.
Picotest EM-6992 Hand Held Probe Set
What's included:
Hand Held EMI Probe Set (EM-6992)
- 6 cm Loop (EM-6993)
- 3 cm Loop (EM-6994)
- 1 cm Loop (EM-6995)
- 3.6 cm Ball (EM-6996)
- Stub (EM-6997)
All probes supplied with BNC connector and custom carrying case.
The EM-6992 Hand Held EMI Probe Set is designed to assist in pinpointing the specific source of emissions during the diagnostic testing phase of an EMI compliance investigation. A selection of probes of varying sensitivities is provided for both E-field and H-field analysis up to 1000 MHz. When used with any 50 ohm measuring instrument the EM-6992 set allows for easy identification of emission sources.
